Thursday, July 15, 2010

REMOTE CONTROL FOR HOME APPLIANCES

Connect this circuit to any of your home appliances (lamp, fan, radio, etc) to make the appliance turn on/off from a TV, VCD or DVD remote control. The circuit can be activated from up to 10 metres. The 38kHz infrared (IR) rays generated by the remote control are received by IR receiver module TSOP1738 of the circuit. Pin 1 of TSOP1738 is connected to ground, pin 2 is connected to the power supply through resistor R5 and the output is taken from pin 3. The
output signal is amplified by transistor T1 (BC558). The amplified signal is fed to clock pin 14 of decade counter IC CD4017 (IC1). Pin 8 of IC1 is grounded, pin 16 is connected to Vcc and pin 3 is connected to LED1 (red), which glows to indicate that the appliance is ‘off.’
The output of IC1 is taken from its pin 2. LED2 (green) connected to pin 2 is used to indicate the ‘on’ state of the appliance. Transistor T2 (BC548) connected to pin 2 of IC1 drives relay RL1. Diode 1N4007 (D1) acts as a freewheeling diode. The appliance to be controlled is connected between the pole of the relay and neutral terminal of mains. It gets connected to live terminal of AC mains via normally opened (N/O) contact when the relay energises

Posted by at

2 comments:

  1. Ines GrunwaldJanuary 15, 2020 at 2:13 AM

    This is really a nice and informative, containing all information and also has a great impact on the new technology. Thanks for sharing it Kenmore, Miele, Bosch, Whilpool washer repair IN ALHAMBRA

    ReplyDelete
  2. Gerald DillinghamMarch 31, 2020 at 4:43 AM

    I recently found many useful information in your website especially this blog page. Among the lots of comments on your articles. Thanks for sharing. best cold press juicer

    ReplyDelete

Subscribe to: Post Comments (Atom)